Vodič za instalaciju Roth QuickTemp kompaktnog sistema

Roth QuickTemp kompaktni sistem

Specifikacije proizvoda

• Dimenzije: 61 cm x 61 cm x 40 cm
• Maksimalno opterećenje: 2 mm po metru
• Potrebna montaža

Planlæg hvordan Compact pladerne skal udlægges. OBS.

  Always read the full documentation

Usisajte podlogu.

Split the turn plate and lay it first.

Žljebovi između ploča moraju biti poravnati.

Cut plates from the back, remove any burrs.

Koristite transferne ploče za dovodne cijevi/za popunjavanje praznina.

Vacuum before installation of pipes.

Naizmjenično postavljajte cijev čvrsto/blizu unutrašnjeg kruga.

Ugradite cijevi i izvršite ispitivanje pritiska.

Vacuum before installation of flooring underlayment

Flooring underlayment. Avoid overlapping.Lay wood floor at a 90° angle to pipes.

• ROTH DANMARK A/S · Tlf. +45 47 38 01 21 ·
  • E-mail: service@roth-danmark.dk · roth-danmark.dk
• ROTH SVERIGE AB · Tel. +46 40 53 40 90 ·
  • E-mail: service@roth-sverige.se · roth-sverige.se
• ROTH NORGE AS · Tel. +47 67 57 54 00 ·
  • E-mail: service@roth-norge.no · roth-norge.no
• ROTH FINLAND OY · Puh. +358 (0)19 440 330 ·
  • S-posti: service@roth-finland.fi · roth-finland.fi
• ROTH UK Ltd. · Phone +44 (0) 1905 453424 ·
  • E-mail: enquiries@roth-uk.com · roth-uk.com

Koraci instalacije

1. Place component A on a flat surface with dimensions 61 cm x 61 cm.
2. Attach component B to component A using the provided screws (X mm).
3. Ensure that the maximum load of 2mm per meter is not exceeded.
4. Connect component C to the assembly following the designated markings.
5. Secure all components in place as per the assembly diagram.
6. Continue adding components in the specified order until the structure is complete.
7. Provjerite stabilnost i po potrebi izvršite podešavanja.
8. Vaš proizvod je sada spreman za upotrebu!

FAQs