Uvod
Thank you for choosing the Stetsom Vulcan 9K EQ - 1 Ohm 9000W RMS Full Range High Power Ampspašivač. Ovaj priručnik pruža bitne informacije za pravilnu instalaciju, rad i održavanje vašeg ampspašivač. Molimo vas da pažljivo pročitate ovaj priručnik prije upotrebe proizvoda kako biste osigurali optimalne performanse i sigurnost.
Važne informacije o sigurnosti
- Uvijek isključite akumulator vozila prije bilo kakvih električnih spajanja.
- Osigurajte ispravno uzemljenje kako biste spriječili električne opasnosti.
- Instalirajte ampLifier u dobro prozračenom prostoru kako bi se spriječilo pregrijavanje.
- Koristite ožičenje odgovarajućeg presjeka za napajanje i priključke zvučnika kako je navedeno u ovom priručniku.
- Izbjegavajte izlaganje ampučvršćivač na vlagu ili ekstremne temperature.
- Ne pokušavajte da otvorite ili popravite amplifier yourself. Refer all servicing to qualified personnel.
Product Overview
The Stetsom Vulcan 9K EQ is a high-power, full-range digital amplifier designed for automotive audio systems. It features a robust design and advanced equalization capabilities to deliver powerful and clear sound reproduction.
Ključne karakteristike:
- 9000W RMS power output at 1 Ohm (12.6V)
- Full Range frequency response (10Hz to 15KHz)
- Built-in 3-band equalizer (Bass, Mid Bass, Mid High)
- Over Clip +15% Power indicator
- Protection circuits for safe operation
Identifikacija komponente:
The amplifier features power, protection, and clip indicators on the front panel. The input and output terminals are located on the side for easy access during installation.
Instalacija i podešavanje
1. Priključci za napajanje:
- Power Cable (B+): Connect a heavy-gauge power cable directly from the positive terminal of the vehicle's battery to the B+ terminal on the amplifier. An inline fuse or circuit breaker (not included) must be installed within 18 inches (45 cm) of the battery.
- Uzemljeni kabel (GND): Spojite debeli kabel za uzemljenje s GND terminala na amplifier to a clean, unpainted metal surface of the vehicle chassis. Ensure a solid, low-resistance connection.
- Daljinsko uključivanje (REM): Spojite žicu za daljinsko uključivanje s izlaza za daljinsko upravljanje vaše glavne jedinice na REM terminal na ampuređaj za spašavanje. Ova žica signalizira amplifier za uključivanje i isključivanje zajedno s vašim audio sistemom.
2. Audio Input Connections:
Connect RCA cables from your head unit's pre-out (RCA output) to the RCA input jacks on the amplifier. Ensure correct left and right channel connections if applicable, though this is a mono amplifier.
3. Speaker Output Connections:
Connect your subwoofer(s) or full-range speakers to the speaker output terminals on the amplifier. Pay close attention to polarity (+ and -) and ensure the total impedance of your speakers matches the amplifier's rated impedance (1 Ohm for this model). Refer to the specifications section for impedance details.
4. Montaža:
Montirajte amplifier securely in a location that provides adequate ventilation and protection from moisture. Avoid mounting it directly on carpet or in enclosed spaces without airflow.
Uputstvo za upotrebu
1. Početno uključivanje:
After all connections are made, reconnect the vehicle's battery. Turn on your head unit. The "POWER" indicator on the amplifier should illuminate, indicating it is receiving power and is operational.
2. Podešavanje pojačanja:
Podesite kontrolu pojačanja na amplifier koji odgovara izlaznoj jačinitage of your head unit. Start with the gain at its minimum setting. Play a familiar track at about 75% of your head unit's maximum volume. Slowly increase the amplifier's gain until you hear distortion, then back it off slightly. The "CLIP" indicator should only flash briefly on very dynamic peaks, not stay illuminated.
3. Crossover Settings:
The Vulcan 9K EQ features adjustable crossovers:
- Niskopropusni filter (LPF): Adjust this control to set the upper frequency limit for your subwoofers. Frequencies above this setting will be attenuated.
- Visokopropusni filter (HPF): Adjust this control to set the lower frequency limit for your speakers. Frequencies below this setting will be attenuated. This is typically used for full-range speakers or mid-bass drivers.
Refer to your speaker manufacturer's recommendations for optimal crossover points.
4. Equalizer Adjustment (3-Band EQ):
The amplifier includes a 3-band equalizer to fine-tune the audio output:
- bas: Podešava niskofrekventni odziv.
- srednji bas: Adjusts the mid-low frequency response.
- srednja visoka: Adjusts the mid-high frequency response.
Make small adjustments and listen carefully to achieve your desired sound balance. Avoid excessive boosting, which can lead to distortion or speaker damage.
Održavanje
- Zadrži ampČistite filter, bez prašine i ostataka. Za čišćenje koristite meku, suhu krpu.
- Osigurajte adekvatan protok zraka oko amplifier at all times to prevent overheating. Regularly check that cooling fins are not obstructed.
- Povremeno provjeravajte sve spojeve ožičenja na čvrstoću i koroziju. Labavi spojevi mogu uzrokovati probleme s performansama ili oštećenje.
Vodič za rešavanje problema
| Problem | Mogući uzrok | Rješenje |
|---|---|---|
| Nema napajanja / AmpLifier se ne uključuje |
|
|
| Nema izlaza zvuka |
|
|
| Amplifier in Protection Mode (PROT light on) |
|
|
| Distorted Sound |
|
|
Tehničke specifikacije
| Feature | Vrijednost |
|---|---|
| RMS Power at 1 Ohm (12.6V) | 1 x 9,000 W RMS |
| RMS Power at 2 Ohm (12.6V) | 1 x 5,400 W RMS |
| RMS Power at 4 Ohm (12.6V) | 1 x 3,200 W RMS |
| RMS Power at 1 Ohm (13.8V) | 1 x 10,000 W RMS |
| RMS Power at 2 Ohm (13.8V) | 1 x 6,400 W RMS |
| RMS Power at 4 Ohm (13.8V) | 1 x 3,900 W RMS |
| Snabdijevanje voltage | 9.5 ~ 15V |
| Frekvencijski odziv | 10Hz ~ 15KHz |
| Crossover Low Pass | 50Hz ~ 15KHz |
| Crossover High Pass | 10 Hz ~ 70 Hz |
| Odnos signala i šuma | > 90 dB |
| Harmonic Distortion (THD) | < 0.9 % |
| Input Sensitivity | 0.2V |
| Input Impedance | 27K Ohma |
| Izlazna impedansa | 1 Ohm |
| Consumption (Musical Signal) | 6.7A ~ 445A (12.6V) |
| Consumption (Bass Signal) | 6.7A ~ 890A (12.6V) |
| Dimenzije (V x Š x D) | 75.5 x 308 x 510 mm |
| Težina | 7.4 Kg |
Garancija i podrška
Stetsom products are manufactured to the highest quality standards. For specific warranty terms and conditions, please refer to the warranty card included with your product or visit the official Stetsom website. For technical support or service inquiries, please contact your authorized Stetsom dealer or Stetsom customer service.
Webstranica: www.stetsom.com.br (Npramplink, stvarni link se može razlikovati)
