AEM 1-1000 Synthetic Air Filter Cleaner with Trigger Sprayer - 32 oz. Instruction Manual

Uvod

The AEM 1-1000 Synthetic Air Filter Cleaner is designed to effectively loosen and dissolve dirt and grime buildup on synthetic air filters. This cleaner allows for easy rinsing with water, ensuring your filter remains clean and performs optimally. It is specifically formulated for AEM Dryflow air filters and is suitable for other synthetic air filter types.

• Rinse filter with water after using
• Loosens and dissolves dirt and grime
• Designed for AEM Dryflow air filters
• Zemlja porijekla: Sjedinjene Američke Države

Sigurnosne informacije

DANGER: CORROSIVE

KEEP OUT OF REACH OF CHILDREN. SEE BACK LABEL FOR ADDITIONAL INFORMATION.

Prva pomoć:

• Ako u oči: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice and attention or call Poison Control Center at 1-800-222-1222 immediately.
• Ako je na koži: Wash with plenty of soap and water. If skin irritation occurs: Get medical advice and attention.
• Ako se proguta: Call a Poison Control Center or doctor immediately. Do not induce vomiting.

Contains: Tetrasodium EDTA, Diethylene glycol monobutyl ether.

Wear eye and face protection. Wash face, hands and any exposed skin thoroughly after handling.

Image: Back of the AEM 1-1000 Air Filter Cleaner bottle, detailing safety information and usage instructions.

Operating Instructions: Cleaning Your Synthetic Air Filter

Follow these steps to clean your AEM Dryflow or other synthetic air filter using the AEM 1-1000 cleaner:

1. Priprema: Remove the air filter from your vehicle. Gently tap the filter to dislodge any loose dirt or debris.
2. Nanesite čistač: Liberally spray the AEM 1-1000 cleaner onto both sides of the air filter element. Ensure thorough coverage.
3. Natapanje: Allow the cleaner to soak into the filter for approximately 20 minutes. Do not allow the cleaner to dry on the air filter.
4. Ispiranje: Rinse the filter element with cool, low-pressure water. Always rinse from the clean side (inside) out to flush dirt and cleaner residue out of the filter. Continue rinsing until all traces of the cleaner are gone and the water runs clear.
5. Excess Water Removal: Gently shake off any excess water from the filter.
6. Sušenje: Allow the filter to air dry completely. Do not use compressed air or heat to dry the filter, as this can damage the filter media. Place it in a well-ventilated area, ideally in sunlight, to expedite drying.
7. Ponovna instalacija: Once completely dry, re-install the clean air filter into your vehicle.

Napomena: AEM Dryflow air filters are synthetic and do not require oiling after cleaning. If you are cleaning a different type of synthetic filter, consult its manufacturer's instructions regarding post-cleaning treatment.

Slika: Front view of the AEM 1-1000 Synthetic Air Filter Cleaner, 32 oz. bottle.

Specifikacije

Garancija i podrška

For specific warranty information or technical support regarding your AEM 1-1000 Synthetic Air Filter Cleaner, please refer to the product packaging or visit the official AEM website. You can also contact AEM customer service directly for assistance.

For more AEM products and information, visit the AEM Store on Amazon.