1. Uvod
This manual provides detailed instructions for the installation, operation, and maintenance of the Marley T200 Qmark Electric Line Voltage Wall Thermostat. The T200 is a wall-mounted, double-pole, heating-only thermostat designed for precise control of electric heating systems. It features a built-in heat anticipator for consistent temperature regulation and a snap-action design for extended operational life. Please read this manual thoroughly before installation and use.
2. Sigurnosne informacije
UPOZORENJE: Risk of electric shock. This device operates on line voltage (277 Volts). Improper installation or handling can result in serious injury or death. Always turn off power at the main service panel before installing or servicing this thermostat.
- Instalaciju mora izvršiti kvalificirani električar u skladu sa svim lokalnim i nacionalnim električnim propisima.
- Do not install in locations where it may be exposed to water or excessive humidity.
- Uvjerite se da su svi spojevi ožičenja sigurni i pravilno izolirani.
- Nemojte prekoračiti navedeni volumentage or current ratings of the thermostat.
3. Sadržaj paketa
Prije početka instalacije provjerite da li su sve komponente prisutne:
- Marley T200 Line Voltage Zidni termostat
- Vijci za montažu (obično uključeni)
- Uputstvo za upotrebu (ovaj dokument)
4. Instalacija
The Marley T200 thermostat is designed for wall-mount installation. Ensure the power supply to the heating system is disconnected at the circuit breaker before proceeding.
4.1 Ožičenje
The T200 thermostat requires a 277 Volt power supply. It features three pre-stripped wires for connection:
- Connect the two red wires to the incoming 277V line voltage snabdijevanje.
- Connect the black wire to the heating load (e.g., electric heater).
- Ensure all connections are made using appropriate wire nuts or connectors and are securely tightened.
Refer to the diagram below for visual guidance on the thermostat's wiring and components.

Slika 1: The Marley T200 thermostat showing its off-white rectangular body, a brass-colored temperature dial with markings from 50 to 90 degrees Fahrenheit and an 'OFF' position, and three exposed electrical wires (two red, one black) extending from the left side for connection to the line voltage and heating load. The 'MARLEY' brand name is visible at the bottom front.
4.2 Montaža
After wiring, carefully push the thermostat into the wall box. Secure the thermostat to the wall box using the provided mounting screws. Ensure the thermostat is flush with the wall surface.
5. Uputstvo za upotrebu
The Marley T200 thermostat features a simple manual control dial for setting the desired temperature.
- Podešavanje temperature: Rotate the central dial clockwise to increase the desired temperature or counter-clockwise to decrease it. The temperature range is from 50°F to 90°F.
- OFF pozicija: To turn off the heating system, rotate the dial counter-clockwise until it reaches the 'OFF' position. This will completely disconnect power to the heating load.
- The built-in heat anticipator helps maintain a consistent room temperature by cycling the heating system more frequently for shorter durations, preventing wide temperature swings.
6. Održavanje
The Marley T200 thermostat requires minimal maintenance.
- čišćenje: Periodically wipe the exterior of the thermostat with a soft, dry cloth to remove dust. Do not use abrasive cleaners or solvents.
- Nema dijelova koje može servisirati korisnik: Unutar termostata nema dijelova koje korisnik može sam servisirati. Ne pokušavajte otvarati ili popravljati uređaj.
7. Otkrivanje problema
If you experience issues with your Marley T200 thermostat, consider the following:
- Bez vrućine:
- Check if the thermostat dial is set to the 'OFF' position.
- Ensure the circuit breaker for the heating system is not tripped.
- Verify that the thermostat is properly wired and all connections are secure (consult a qualified electrician if unsure).
- Nedosljedna temperatura:
- Pazite da termostat nije postavljen u blizini izvora topline (npr. direktne sunčeve svjetlosti,amps) or drafts, which can affect its accuracy.
- The thermostat has a differential of 2.5 degrees, meaning it will cycle the heat within a 2.5-degree range of the set point.
For persistent issues, contact a qualified electrician or Marley customer support.
8. Specifikacije
| Brand | Marley |
| Naziv modela | T200 |
| Voltage | 277 Volts |
| Temperaturni opseg | 50°F - 90°F |
| Diferencijal | 2.5°F |
| Tip kontrole | Manual (Dial) |
| Vrsta montaže | Zidni nosač |
| Materijal | Plastika, bakar |
| Dimenzije proizvoda | 2.5 x 3.13 x 4.5 inča |
| Težina artikla | 8.8 unce |
| Izvor napajanja | Corded Electric |
9. Garancija i podrška
Specific warranty information for the Marley T200 thermostat is not provided in this document. For details regarding warranty coverage, technical support, or replacement parts, please contact Marley customer service directly or refer to the official Marley webSačuvajte račun kao dokaz o kupovini.





