Linearni višekodni odašiljač sa tastaturom 420001 Korisnički priručnik

Uvod

This manual provides instructions for the installation, operation, and maintenance of the Linear Multi-Code Keypad Transmitter, model 420001. This wireless keypad is designed for use with Multi-Code Receivers to control access to garage doors or gates.

Product Overview

The Linear Multi-Code Keypad Transmitter 420001 is a 12-button alphanumeric keypad. It operates on a 300 MHz frequency and features 10 dip switches for programming. Its weatherproof casing osigurava izdržljivost za vanjsku upotrebu.

Slika: Front view of the Linear Multi-Code Keypad Transmitter 420001, showing the 12-button alphanumeric keypad and the "MULTI-CODE" branding at the top.

Postavljanje i instalacija

1. Instalacija baterije

   The keypad requires one 9V alkaline battery (not included). To install:

   • Otvorite tastaturu casing.
   • Spojite 9V bateriju na kopču za bateriju.
   • Place the battery securely within the compartment.
   • Zatvorite tastaturu casing, ensuring it is sealed properly for weather resistance.

2. Montaža

   The keypad is designed for screw-in installation and mounts with two screws.

   • Choose a suitable location for mounting, ensuring it is within range of your Multi-Code Receiver.
   • Mark the positions for the two mounting screws.
   • Izbušite pilot rupe ako je potrebno.
   • Secure the keypad to the surface using appropriate screws.

3. Programiranje tastature

   This keypad uses 10 dip switches for programming. The code is entered directly through the keypad, eliminating the need to manually adjust physical dip switches on the unit itself.

   1. Locate the dip switch settings on your Multi-Code Receiver or existing remote. This will be a sequence of 10 switches, each set to ON, OFF, or MIDDLE (if applicable).
   2. On the 420001 keypad, enter the 10-digit code corresponding to your receiver's dip switch settings. Refer to the keypad's internal instructions for specific key presses to represent ON, OFF, or MIDDLE positions.
   3. Press the "ACCESS" button to save the code.
   4. Test the keypad to ensure it operates your garage door or gate opener.

   Napomena: Programming typically takes less than 2 minutes. Ensure the keypad is within operational range of the receiver during testing.

Uputstvo za upotrebu

To operate your garage door or gate using the Linear Multi-Code Keypad Transmitter:

1. Enter your programmed 10-digit access code using the alphanumeric buttons.
2. Press the "ACCESS" button.
3. The LED indicator will illuminate, and your Multi-Code Receiver should activate, opening or closing your garage door or gate.

If the door or gate does not respond, verify your code and ensure the keypad is within effective range of the receiver.

Održavanje

• Zamjena baterije: When the keypad's performance degrades or the LED indicator fails to light, replace the 9V battery. Follow the battery installation steps.
• čišćenje: Clean the keypad's exterior with a soft, damp krpom. Izbjegavajte abrazivna sredstva za čišćenje ili rastvarače.
• Otpornost na vremenske uvjete: The keypad features a weatherproof casing. Ensure the casing is properly closed and sealed after any internal access (e.g., battery replacement) to maintain its weather-resistant properties.

Rješavanje problema

Specifikacije

Garancija i podrška

Za informacije o garanciji ili tehničkoj podršci, obratite se službenom servisu proizvođača webweb-mjesto ili kontaktirajte njihovu službu za korisnike. Sačuvajte račun za kupovinu u slučaju reklamacije.

Proizvođač: Linearno