Uvod
Thank you for choosing the BUTURE BC02 Car Jump Starter with Air Compressor. This versatile device combines a powerful jump starter, a portable air compressor, a power bank, and an emergency light, making it an essential tool for any vehicle owner. Please read this manual carefully before use to ensure safe and optimal operation.
Figure 1: BUTURE BC02 Jump Starter and included accessories.
Važne informacije o sigurnosti
- Uvijek nosite zaštitu za oči pri radu s baterijama.
- Do not allow the jump starter clamps to touch each other once connected to the device.
- Nemojte pokušavati pokrenuti zamrznutu bateriju.
- Ensure the device is fully charged before use for optimal performance.
- Čuvati van domašaja djece.
- Ne izlažite uređaj ekstremnim temperaturama ili vlazi.
- If the device becomes excessively hot during use, discontinue operation immediately.
Sadržaj paketa
Molimo Vas da provjerite paket za sljedeće stavke:
- BUTURE BC02 Jump Starter with Air Compressor
- Pametna baterija Clamps
- Air Hose
- Nozzle Adapters (for various inflatables)
- USB-C kabl za punjenje
- Uputstvo za upotrebu
- Torba za pohranu
Podešavanje i početno punjenje
Before first use, ensure the BUTURE BC02 is fully charged. The device features a large LED screen that displays the battery level.
- Connect the provided USB-C charging cable to the USB-C input port on the device.
- Connect the other end of the USB-C cable to a suitable USB wall adapter (not included) or car charger.
- The LED screen will indicate charging status and battery percentage. Charge until the screen shows 100%.
Figure 2: Charging the BC02 and using it as a power bank.
It is recommended to recharge the device every 3-6 months, even if not in use, to maintain battery health.
Uputstvo za upotrebu
1. Paljenje vozila pomoću kablova
The BUTURE BC02 can jump start vehicles with up to 9.0L gas engines and 8.0L diesel engines.
- Ensure the jump starter is sufficiently charged (at least 50% recommended).
- Umetnite pametnu bateriju clamp plug firmly into the jump starter's 12V output port. The indicator light on the clamp naizmjenično će treptati crveno i zeleno.
- Spojite crveni (+) clamp na pozitivni (+) pol akumulatora vozila.
- Spojite crni (-) clamp na negativni (-) pol akumulatora vozila.
- Nakon ispravnog povezivanja, indikatorska lampica na pametnom telefonu će se upaliti.amp will turn solid green. If it flashes red or beeps, check connections or refer to the troubleshooting section.
- Pokrenite svoje vozilo u roku od 30 sekundi.
- Čim se vozilo pokrene, odmah uklonite pametni ključ.amp from the vehicle battery, then disconnect it from the jump starter.
Figure 3: Easy steps to jump start your vehicle.
Force Start Function: If the battery is extremely low and the smart clamp does not show a solid green light, consult the troubleshooting section for instructions on using the force start function (if available and safe for your vehicle).
2. Using the 150PSI Air Compressor
The integrated air compressor can inflate tires and other inflatables up to 150 PSI with smart preset and auto-stop features.
- Pritisnite dugme za napajanje da uključite uređaj.
- Connect the air hose to the inflation port on the device and tighten it.
- Attach the other end of the air hose to the item you wish to inflate (tire valve, ball needle, etc.). Use the appropriate nozzle adapter if necessary.
- Short press the 'M' button to enter inflation mode.
- Press 'M' again to cycle through inflation modes (Car, Motorcycle, Bicycle, Ball, Custom) or 'U' to change pressure units (PSI, BAR, KPA).
- Use the '+' and '-' buttons to set the desired pressure.
- Long press the power button for 3 seconds to start inflation. The compressor will automatically stop when the preset pressure is reached.
- Once inflation is complete, disconnect the air hose from the item and the device.
Figure 4: Steps for using the air compressor.
Inflation Pressure Ranges:
- Car: 26-51 PSI
- Motorcycle: 26-44 PSI
- Bicycle: 30-65 PSI
- Ball: 4-16 PSI
- Custom Inflation: 0-150 PSI
Figure 5: Recommended inflation ranges for various items.
3. Korištenje kao prijenosne power banke
The BC02 can charge your electronic devices on the go.
- Connect your device's charging cable to the USB-A output port (5V/2.4A) on the jump starter.
- Jump starter će automatski početi puniti vaš uređaj.
- The USB-C port can also be used for input (5V/2A, 9V/2A, 12V/1.5A) to recharge the jump starter itself.
Figure 6: Charging mobile devices with the BC02.
4. Emergency Lights
The device features a 500-lumen LED light with multiple modes for emergency situations.
- Press the light button once for a steady flashlight.
- Press again for white strobe light.
- Press a third time for red strobe light (warning triangle).
- Press a fourth time for SOS signal.
- Press a fifth time to turn off the light.
Figure 7: Emergency light functions.
Održavanje
- čišćenje: Obrišite uređaj mekom, suhom krpom. Ne koristite jake hemikalije ili abrazivne materijale.
- Skladištenje: Uređaj čuvajte na hladnom i suhom mjestu, dalje od direktne sunčeve svjetlosti i ekstremnih temperatura.
- Punjenje: Recharge the device every 3-6 months to maintain battery life, even if not in use.
- Održavanje baterije: Izbjegavajte često potpuno pražnjenje baterije.
Rješavanje problema
Specifikacije
Korisnički saveti
- Always keep the jump starter charged, especially before long trips or during cold weather.
- Familiarize yourself with the different inflation modes and pressure units before an emergency.
- Store the device in an easily accessible location in your vehicle.
- Test the emergency light functions periodically to ensure they are working.
Garancija i podrška
Za informacije o garanciji, tehničkoj podršci ili upite o servisiranju, obratite se direktno prodavcu ili proizvođaču. Sačuvajte račun kao dokaz o kupovini.
