Avisontek 3060 MCS306010

Avisontek MultiCode Garage Door Opener Remote Instruction Manual

Models: 3089, 3060, 3070, 308911, MCS308911

Brand: Avisontek

Uvod

This manual provides comprehensive instructions for the Avisontek MultiCode Garage Door Opener Remote. This remote is designed for compatibility with 300MHz, 10-dip switch MultiCode gate and garage door openers, including models 3089, 3060, 3070, 308911, and MCS308911. Please read these instructions carefully before setup and operation to ensure proper functionality and safety.

Two Avisontek MultiCode garage door opener remotes with keychains

Image: Two Avisontek MultiCode garage door opener remotes, black with a single grey button and a red indicator light, attached to metal keychains.

Uputstva za postavljanje

The Avisontek MultiCode remote is designed for easy pairing with compatible garage door and gate openers. Ensure your existing opener operates on a 300MHz frequency and uses a 10-dip switch system.

Universal Compatibility graphic showing compatible MultiCode models and a 10-dip switch diagram

Image: A graphic illustrating universal compatibility, specifically for 300MHz Linear MultiCode systems with 10 DIP switches, listing compatible models 3089, 3060, and 3070.

Postavljanje dip prekidača

  1. Locate the dip switches on your existing MultiCode remote or the receiver unit of your garage door/gate opener. These are typically small switches numbered 1 through 10.
  2. Open the battery compartment of your new Avisontek remote to access its dip switches.
  3. Using a small tool like a pen or a toothpick, carefully match the ON/OFF positions of the 10 dip switches on your new Avisontek remote to precisely match the configuration of your existing remote or receiver. Ensure each switch is set identically.
  4. Zatvorite odeljak za baterije.
Diagram showing 10 dip switches with ON and OFF positions

Image: A diagram illustrating the 10 dip switches, numbered 1 through 10, with clear indications for the 'ON' and 'OFF' positions. The 'ON' position is when the switch is depressed towards the number.

After setting the dip switches, your remote should be ready for operation.

Uputstvo za upotrebu

To operate your garage door or gate, simply press the single button on the Avisontek remote. A brief press is sufficient to send the signal. The remote features a fixed code technology for enhanced security and offers a reliable operating range of over 164 feet.

Hand pressing the Avisontek remote button with a garage door in the background

Image: A hand pressing the button on the Avisontek remote, with a modern garage and a green garage door in the background, illustrating the remote's long operating range.

The compact design allows for easy attachment to a keychain or placement in your vehicle for convenient access.

Održavanje

Zamjena baterije

The remote is powered by a high-capacity 12V 27A alkaline battery, designed for extended usage. When the remote's performance diminishes or the indicator light fails to illuminate, it may be time to replace the battery.

Avisontek remote with a graphic of a 12V 27A alkaline battery

Image: The Avisontek remote shown alongside a graphic representation of a 12V 27A alkaline battery, highlighting its high-capacity for extended use.

  1. Carefully open the remote's casing, typically by removing a small screw or prying open a seam with a flat tool.
  2. Uklonite staru bateriju od 12 V i 27 A.
  3. Insert a new 12V 27A alkaline battery, ensuring correct polarity (+ and -).
  4. Close the remote's casing sigurno.

Rješavanje problema

  • Daljinski ne radi:
    • Verify that the dip switches on your Avisontek remote precisely match those on your original remote or receiver. Even a single switch mismatch will prevent operation.
    • Check the battery. Replace it with a new 12V 27A alkaline battery if the indicator light does not illuminate or is dim.
    • Ensure you are within the operating range (over 164 feet) of your garage door or gate opener.
  • Slow or Intermittent Response:
    • This can often indicate a low battery. Replace the 12V 27A battery.
    • Provjerite da nema prepreka između daljinskog upravljača i prijemnika.
  • Remote Indicator Light Not On:
    • The battery is likely depleted or incorrectly installed. Replace the battery and check polarity.

Specifikacije

Product parameter graphic showing dimensions, range, frequency, and other specifications

Image: A detailed graphic displaying the product parameters including dimensions, working range, frequency, battery type, and material.

FeatureDetalj
Brojevi modela3089, 3060, 3070, 308911, MCS308911
Kompatibilnost300MHz 10 Dip Switch MultiCode Gate/Garage Door Openers
Working RangePreko 164 stopa
Frekvencija300MHz
Tip kodiranja10 Dip Switch Fixed Code
Vrsta baterije12V 27A Alkaline (2 included)
Materijal školjkeABS legura
Dimenzije proizvoda2.12 x 1.57 x 0.47 inča
Težina artikla1.76 unci (0.066 lbs)
BojaCrna

Informacije o garanciji

Avisontek provides a 3 godine garancije for this product. This warranty covers manufacturing defects and ensures your investment is protected. For any issues covered under warranty, please contact customer support for a return or exchange.

Korisnička podrška

For any queries, technical assistance, or warranty claims, Avisontek offers 24-hour online support. Our products are FCC certified for North American standards.

Customer support representative with headset, indicating 24-hour online tech support

Image: A customer support representative wearing a headset, symbolizing 24-hour online technical support, alongside FCC certification and 3-year warranty information.

You can reach us through the 'Ask a question' feature on our store homepage or via our support email. We aim to respond to all inquiries within 24 hours.

© 2025 Avisontek. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.