Avisontek 2-Pack Genie Garage Door Opener Remote Instruction Manual

1. Uvod

This manual provides instructions for the setup, operation, and maintenance of your Avisontek 2-Pack Genie Garage Door Opener Remote. This remote is designed for wide compatibility with Genie Intellicode garage door openers manufactured from 1997 to the present.

Važna napomena o kompatibilnosti: This remote is NE compatible with garage door openers that use DIP switches. Please verify your opener type before proceeding with programming.

Slika 1.1: Kompatibilnost prekoview. The remote replaces various Genie Intellicode models from 1997 to present but does not support remotes with DIP switches.

2. Specifikacije

The following table outlines the key specifications for your Avisontek garage door opener remote:

Image 2.1: Detailed product parameters and dimensions for the remote.

3. Setup and Programming Instructions

Follow these steps to program your Avisontek remote to your Genie garage door opener. Ensure you are within 5 feet of your opener during programming.

Step 1: Put Opener into Programming Mode

For New Openers:

1. Press and hold the program button on your garage door opener until the round LED turns blue, then release.
2. The round LED will go out, and the long LED will begin flashing purple.

For Genie Openers and External Receivers Manufactured between 1995 to 2011:

• Press and release the Learn Code button once. The red LED will begin to flash.

Step 2: Program a Remote to Your Opener

Note: Once in programming mode, you have approximately 30 seconds to perform this step.

1. While approximately 5 feet away from the opener, slowly press and release the desired button on your remote twice. The opener LEDs will flash and go off, indicating successful programming.
2. Press and release the same remote button a third time. It is possible to press the remote button too quickly or lightly. If the LEDs do not turn off, press the remote button several more times to achieve confirmation.

Step 3: Lost or Stolen Remote / Erasing All Remotes

For New Openers:

1. Pritisnite i držite dugme za program sve dok okrugla LED dioda ne postane plava, a zatim otpustite.
2. Press and hold the top (▲) and bottom (▼) buttons of the remote until both LEDs flash blue and go off.

For Genie Openers and External Receivers Manufactured between 1995 to 2011:

• To erase all remote devices from all other types of Genie openers, press and hold the Learn Code button until the LED stops blinking.

Note: Clearing remote control memory from the power head will clear all pre-programmed remotes and keypads. Your opener will no longer receive a remote signal from any remote device, including a missing remote device.

Image 3.1: Visual guide for setting up and syncing the remote with your garage door opener.

4. Uputstvo za upotrebu

Once programmed, your Avisontek remote is ready for use. Each of the three buttons on the remote can be programmed to operate a different garage door opener, allowing control of up to three separate doors.

• Opening/Closing a Garage Door: Press the programmed button corresponding to the desired garage door. The door will open or close.
• Stopping a Garage Door: Press the programmed button again while the door is in motion to stop it.

The remote features an ultra-long range, allowing operation from over 164 feet away, and utilizes rolling code security for enhanced protection.

Image 4.1: The remote offers an effective operating range of up to 164 feet.

Image 4.2: The 3-channel remote can operate up to three different garage doors.

5. Održavanje

Zamjena baterije

The remote uses a 3V CR2032 lithium battery. When the remote's indicator light dims or fails to illuminate upon button press, it is time to replace the battery.

1. Pronađite odeljak za baterije na poleđini daljinskog upravljača.
2. Use a small screwdriver or coin to gently pry open the compartment cover.
3. Uklonite staru CR2032 bateriju.
4. Insert a new 3V CR2032 battery with the positive (+) side facing up.
5. Replace the compartment cover, ensuring it snaps securely into place.

Čišćenje

Wipe the remote with a soft, dry cloth. Avoid using harsh chemicals or abrasive cleaners, as these can damage the remote's finish or internal components.

6. Otkrivanje problema

If your remote is not functioning as expected, consider the following:

• Daljinski ne reaguje: Check the battery. Replace it if the indicator light does not illuminate or is dim.
• Garage door not opening/closing: Ensure the remote is properly programmed to your garage door opener. Refer to the "Setup and Programming Instructions" section.
• Ograničeni domet: Replace the battery. Ensure there are no obstructions between the remote and the garage door opener's antenna.
• Incompatible opener: Confirm your garage door opener is a Genie Intellicode model from 1997-present and does not use DIP switches.

If issues persist after following these steps, please contact customer support for further assistance.

7. Garancija i podrška

Avisontek provides a Sveobuhvatna garancija od 3 godine for this product, ensuring protection and assurance in its quality. The product is also FCC certificirano for North American standards.

For any queries or assistance, please contact Avisontek customer support through the store homepage's "Ask a question" feature or via the provided support email. Support is typically available within 24 hours.

Image 7.1: Avisontek offers a 3-year warranty and customer support.