DAKASON LS-4B-50KFD

DAKASON 4FT LED Linear Light Fixture User Manual

Model: LS-4B-50KFD

1. Uvod

This manual provides detailed instructions for the safe installation, operation, and maintenance of your DAKASON 4FT LED Linear Light Fixture. Please read this manual thoroughly before installation and retain it for future reference. This fixture is designed for commercial and residential indoor illumination, offering selectable wattage i postavke temperature boje.

2. Sigurnosna uputstva

UPOZORENJE: Opasnost od strujnog udara. Isključite napajanje prije instalacije ili servisiranja.

  • Prije početka instalacije provjerite je li glavni dovod struje isključen prekidačem.
  • Instalaciju treba izvršiti kvalificirani električar u skladu sa svim lokalnim i nacionalnim električnim propisima.
  • Do not install in wet locations. This fixture is for indoor use only.
  • Ne mijenjajte uređaj. Bilo kakve modifikacije mogu poništiti garanciju i stvoriti sigurnosne rizike.
  • Handle the fixture with care to prevent damage.
  • Uvjerite se da su svi priključci sigurni i pravilno izolirani.

3. Sadržaj paketa

Prije početka instalacije provjerite da li su sve komponente prisutne:

  • DAKASON 4FT LED Linear Light Fixture (4 units for 4-pack)
  • Mounting Hardware (Ceiling Mount Clips, Suspension Ropes, Screws, Wall Anchors)
  • Uputstvo za upotrebu
Image showing the DAKASON 4FT LED Linear Light Fixture with its dimensions and included mounting hardware for both suspension and flush mount.

Figure 1: Product dimensions and included mounting hardware. The image displays the fixture's length (45.7 inches), width (2.98 inches), and height (2 inches), along with two ceiling mount clips, four screws, four wall anchors, and two suspension ropes.

4. Podešavanje i instalacija

The DAKASON 4FT LED Linear Light Fixture supports both suspension mount and flush mount installations.

4.1. Prije instalacije

  • Isključite struju na prekidaču.
  • Raspakujte uređaj i provjerite da li ima oštećenja.
  • Determine the desired mounting method (suspension or flush).

4.2. Upute za ožičenje

This fixture requires hardwiring. A power cable is NOT included and must be supplied by the installer.

  1. Open the end cap of the fixture by pulling it up as indicated by the arrow.
  2. Connect the electrical wires using appropriate wire caps (not included).
  3. Povežite Crna žicu od uređaja do uživo (L) žicu iz napajanja.
  4. Povežite Bijelo žicu od uređaja do neutralan (N) žicu iz napajanja.
  5. Povežite Zeleno žicu od uređaja do uzemljenje (GND) žicu iz napajanja.
  6. For 0-10V dimming, connect the Ljubičasta žice za Dim+ žica i Grey žice za prigušeno- wire from the 0-10V dimmer (dimmer not included).
  7. Uvjerite se da su svi priključci sigurni i izolirani.
  8. Close the end cap securely after wiring.
Close-up image showing the wiring compartment of the DAKASON LED linear light fixture with wire caps for hardwiring. The power cable is not included.

Figure 2: Wiring connections inside the fixture. Note that wire caps are for hardwire, and the power cord is not included.

4.3. Suspension Mount Installation

  1. Mark the desired locations for the suspension ropes on the ceiling.
  2. Drill pilot holes and install appropriate anchors/screws for the suspension rope mounts.
  3. Attach the suspension ropes to the ceiling mounts and to the fixture's mounting brackets.
  4. Adjust the cable length (up to 78 inches) by pressing the release button on the cable gripper to achieve the desired height.
  5. Ensure the fixture is level and securely suspended.
Close-up image demonstrating how to adjust the suspension cable length by pressing a button on the cable gripper.

Figure 3: Adjusting suspension cable length. Press the button to release and adjust the cable.

4.4. Ugradnja u zid

  1. Mark the desired locations for the ceiling mount clips on the ceiling.
  2. Drill pilot holes and install appropriate anchors/screws for the ceiling mount clips.
  3. Securely attach the ceiling mount clips to the ceiling.
  4. Snap the linear light fixture into the installed ceiling mount clips. Ensure it is firmly seated.
Image showing both suspension mount and flush mount installations of the DAKASON LED linear light fixture in different room settings, along with the mounting hardware.

Slika 4: Pramples of Suspension Mount (left) and Flush Mount (right) installations.

4.5. Povezivanje više uređaja

Multiple DAKASON linear light fixtures can be linked in continuous runs up to 15 fixtures at 120V.

  1. Ensure power is off before linking.
  2. Align the end of one fixture with the linking connector of another.
  3. Slide the fixtures together until they securely connect.
  4. Ensure electrical continuity and mechanical stability between linked fixtures.
Image illustrating the process of linking multiple DAKASON LED linear light fixtures together, showing the internal connectors and how they slide into place.

Figure 5: Steps for linking multiple fixtures. Up to 15 lights can be linked at 120Vac.

5. Uputstvo za upotrebu

After installation, restore power to the fixture. The DAKASON LED Linear Light Fixture offers selectable wattage i postavke temperature boje.

5.1. Selecting Wattage (Power)

The fixture has a selectable wattage switch located on the side. This allows you to choose between 30W, 40W, or 50W to adjust the light output.

  • 30W: Approximately 3,000 lumens.
  • 40W: Approximately 4,000 lumens.
  • 50W: Approximately 5,000 lumens.

CAUTION: Ensure power is OFF before adjusting the wattage switch to prevent electrical hazards.

Image showing the power selectable switch on the DAKASON LED linear light fixture, with options for 50W, 40W, and 30W, and examples of light output in a workshop setting.

Figure 6: Power selectable switch (50W/40W/30W) and corresponding light levels.

5.2. Selecting Color Temperature (CCT)

The fixture also features a selectable color temperature switch, allowing you to choose between 3000K, 4000K, or 5000K.

  • 3000K (Toplo bijela): Provides a warm, inviting light.
  • 4000K (svijetlo bijela): Offers a neutral, balanced light.
  • 5000K (Dnevna svjetlost): Delivers a crisp, bright white light.

CAUTION: Ensure power is OFF before adjusting the CCT switch to prevent electrical hazards.

Image showing the color temperature selectable switch on the DAKASON LED linear light fixture, with options for 3000K Warm White, 4000K Bright White, and 5000K Day White.

Figure 7: Color temperature selectable switch (3000K/4000K/5000K).

5.3. 0-10V Dimming

This fixture is compatible with standard 0-10V dimming systems (dimmer not included) for smooth brightness adjustment.

  • Connect the fixture's purple and gray dimming wires to a compatible 0-10V dimmer as per the dimmer's instructions.
  • Adjust the dimmer to achieve the desired light intensity.
Image showing multiple DAKASON LED linear light fixtures installed in an office setting, demonstrating 0-10V smooth dimming capability.

Figure 8: 0-10V smooth dimming in an office environment.

6. Održavanje

The DAKASON LED Linear Light Fixture requires minimal maintenance.

  • čišćenje: Prije čišćenja provjerite je li napajanje isključeno. Koristite meku, suhu ili blago natopljenu krpu.amp cloth to wipe the fixture. Do not use abrasive cleaners or solvents.
  • inspekcija: Periodically inspect the fixture for any signs of damage, loose connections, or wear. If any issues are found, disconnect power and contact a qualified electrician or customer support.
  • LED: The LED chips are designed for a long service life (50,000 hours) and are not user-replaceable.

7. Otkrivanje problema

If you experience issues with your fixture, refer to the following table:

ProblemMogući uzrokRješenje
Uređaj se ne pali.Nema napajanja; Labava veza ožičenja; Neispravna ugradnja.Check circuit breaker and wall switch; Verify all wiring connections are secure; Contact customer support if the fixture is faulty.
Svjetlosni izlaz je previše slab ili previše svijetao.Netačan wattage postavka; Postavka zatamnjenja preniska/visoka.Podesite vattage switch (ensure power is off first); Adjust the 0-10V dimmer.
Svijetla boja nije onakva kakva se očekivala.Neispravna postavka CCT-a.Adjust the CCT switch (ensure power is off first).
Trepereće svetlo.Unstable power supply; Loose wiring; Incompatible dimmer.Check power supply stability; Secure all wiring connections; Ensure dimmer is 0-10V compatible.

If the problem persists after attempting these solutions, please contact DAKASON customer support.

8. Specifikacije

BrandDAKASON
Broj modelaLS-4B-50KFD
Dimenzije (D x Š x V)45.7" x 2.98" x 2"
MaterijalAluminum Housing + PC Lens
Wattage30W / 40W / 50W Selectable
OsvetljenostDo 5000 lumena (pri 50W)
Temperatura boje (CCT)Mogućnost odabira 3000K / 4000K / 5000K
Voltage120-277 Volti AC
Dimmable0-10V Dimable
Unutrašnja/vanjska upotrebaIndoor
Vrsta montažeFlush Mount / Suspension Mount
CertifikatiETL Listed
Vek trajanja50,000 sati

9. Jamstvo i podrška

9.1. Informacije o garanciji

This DAKASON LED Linear Light Fixture is backed by a 5 godine ograničene garancije od datuma kupovine. Ova garancija pokriva nedostatke u materijalu i izradi pri normalnoj upotrebi. Ne pokriva štetu nastalu nepravilnom instalacijom, nezgodom, pogrešnom upotrebom, zloupotrebom ili neovlaštenim modifikacijama.

Za reklamacije u vezi s garancijom, molimo sačuvajte dokaz o kupovini.

9.2. Korisnička podrška

If you have any questions, require technical assistance, or need to make a warranty claim, please contact DAKASON customer support through the retailer where the product was purchased or visit the official DAKASON webstranica za kontakt informacije.

Online podrška: Visit the DAKASON Store on Amazon

© 2023 DAKASON. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.