EARMOR M30

EARMOR M30 Electronic Hearing Protection Headset User Manual

Model: M30

1. Uvod

Thank you for choosing the EARMOR M30 Electronic Hearing Protection Headset. This manual provides essential information for the safe and effective use of your device. Please read it thoroughly before operation and retain it for future reference. The M30 headset is designed to protect your hearing from harmful noise while allowing you to hear important ambient sounds.

2. Sigurnosne informacije

Always prioritize safety when using hearing protection. Failure to follow these instructions may result in hearing damage or other injuries.

  • Ensure the headset is properly fitted to achieve the stated Noise Reduction Rating (NRR).
  • Do not modify the headset. Unauthorized modifications may compromise its protective capabilities.
  • Držite baterije van domašaja dece.
  • Remove batteries if the headset will not be used for an extended period to prevent leakage.
  • The headset is not waterproof. Avoid exposure to excessive moisture.

3. Sadržaj paketa

Provjerite da li se sve stavke nalaze u vašem paketu:

  • EARMOR M30 Electronic Hearing Protection Headset
  • Korisnički priručnik (ovaj dokument)
  • AAA Batteries (quantity may vary, typically 2)

4. Podešavanje

4.1 Instalacija baterije

  1. Pronađite pretince za baterije na svakoj slušalici.
  2. Gently slide open the battery compartment covers.
  3. Insert two AAA batteries into each compartment, ensuring correct polarity (+/-).
  4. Čvrsto zatvorite poklopce odeljka za baterije.
EARMOR M30 Headset with battery compartment visible

Figure 1: EARMOR M30 Headset showing the location of the battery compartments. Ensure correct battery orientation.

4.2 Podešavanje slušalica

For optimal hearing protection and comfort, proper fit is crucial.

  1. Extend the headband by pulling the earcups downwards until they fit comfortably over your ears.
  2. Ensure the earcups fully enclose your ears, creating a tight seal against your head.
  3. Adjust the headband so that it rests securely on the top of your head.

5. Uputstvo za upotrebu

5.1 Uključivanje/isključivanje

  • Za uključivanje: Press and hold the power button (usually located on one earcup) for approximately 3 seconds until you hear an audible confirmation tone.
  • Za isključivanje: Press and hold the power button again for approximately 3 seconds until you hear a different audible confirmation tone.
Close-up of EARMOR M30 earcup showing power and volume buttons

Figure 2: Control panel on the EARMOR M30 earcup, highlighting the power and volume buttons.

5.2 Kontrola jačine zvuka

The M30 headset features independent volume controls for ambient sound amplifikacija.

  • Povećajte jačinu zvuka: Press the '+' button to increase the amplification level of ambient sounds.
  • Smanji jačinu zvuka: Press the '-' button to decrease the amplification level of ambient sounds.

5.3 Noise Reduction Functionality

The EARMOR M30 is an electronic hearing protector designed to reduce harmful impulse noises (e.g., gunshots) to a safe level while amplifying low-level sounds (e.g., conversation, range commands). This allows for situational awareness without compromising hearing safety.

The electronic circuitry instantly suppresses loud noises above a certain decibel threshold, protecting your hearing. When the noise subsides, the amplification returns to its set level.

6. Održavanje

6.1 Čišćenje

  • Wipe the exterior of the headset with a soft, damp tkanina. Nemojte koristiti abrazivna sredstva za čišćenje ili rastvarače.
  • Pazite da vlaga ne uđe u elektronske komponente.
  • Periodically inspect the ear cushions for wear and tear. Replace them if they become damaged to maintain proper seal and protection.

6.2 Skladištenje

Store the headset in a cool, dry place away from direct sunlight and extreme temperatures. Remove batteries if storing for extended periods.

6.3 Zamjena baterije

Replace batteries when the headset indicates low power (e.g., flashing light, audible low battery warning). Refer to Section 4.1 for battery installation instructions.

7. Otkrivanje problema

ProblemMogući uzrokRješenje
Slušalice se ne uključuju.Prazne ili nepravilno instalirane baterije.Provjerite polaritet baterija. Zamijenite novim AAA baterijama.
Nema zvuka ili je zvuk vrlo tih.Volume too low; batteries low; earcup seal compromised.Increase volume using the '+' button. Replace batteries. Adjust headset for a proper seal.
Izobličen zvuk.Low batteries; moisture in electronics.Replace batteries. Ensure headset is dry.
Headset uncomfortable or loose.Nepravilno podešavanje.Adjust headband and earcups for a snug, comfortable fit as described in Section 4.2.

8. Specifikacije

FeatureDetalj
ModelM30
Ocjena smanjenja buke (NRR)24 dB
Ocjena jednog broja (SNR)24 decibela
Kontrola bukeZvučna izolacija
Izvor napajanjaAAA Batteries (typically 2 per earcup)
Vrsta materijalaPolimer
Fit TypeStandard
BojaBrown

9. Videozapisi proizvoda

U dostavljenim podacima za ugradnju u ovaj priručnik nisu pronađeni službeni videozapisi proizvoda od prodavca.

10. Garancija i podrška

For warranty information, please refer to the documentation included with your product packaging or visit the official EARMOR website. For technical support or further assistance, please contact EARMOR customer service through their official channels.

© 2023 EARMOR. Sva prava pridržana.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.