Lutron LECL-153P-WH-3 Lumea CL Dimmer Switch Instruction Manual

1. Uvod

The Lutron LECL-153P-WH-3 Lumea CL Dimmer Switch is designed to provide optimal dimming performance for a wide range of bulb types, including 150W dimmable LED/CFL bulbs or 600W incandescent/halogen bulbs. This dimmer can be installed in either single-pole or 3-way applications. It features a large rocker switch for turning lights on and off, and a smooth slide control for adjusting brightness levels. This manual provides detailed instructions for safe installation, operation, and maintenance of your dimmer switch.

Slika 1: Front view of the Lutron LECL-153P-WH-3 Lumea CL Dimmer Switch. This image shows the large rocker switch at the top for power control and the vertical slide control for adjusting light intensity.

2. Sigurnosne informacije

Please read and understand all instructions before installing or operating this product. Improper installation can result in serious injury or death. Always turn off power at the circuit breaker before beginning any electrical work.

• UPOZORENJE: OPASNOST OD ŠOKA. To avoid serious injury or death, always turn off power at the circuit breaker or fuse box before wiring.
• Instalirajte u skladu sa svim nacionalnim i lokalnim električnim propisima.
• Use only with 120 V~ 60 Hz.
• Samo za unutrašnju upotrebu.
• Ako niste sigurni u bilo koji dio ovih uputa, obratite se kvalificiranom električaru.
• Do not use with non-dimmable bulbs.

3. Sadržaj paketa

Vaš paket bi trebao sadržavati sljedeće stavke:

• Lutron LECL-153P-WH-3 Lumea CL Dimmer Switch (3 units)
• Wire Connectors (typically included for installation)
• Uputstvo za upotrebu (ovaj dokument)

4. Postavljanje i instalacija

4.1. Priprema

1. Isključite napajanje: At the circuit breaker, turn off the power to the switch location.
2. Uklonite postojeći prekidač: Carefully remove the wallplate and mounting screws from the existing switch. Pull the switch out of the wall box.
3. Identifikujte žice: Identify the wires connected to the existing switch. Typically, these include a hot (line) wire, a load wire (to the light fixture), and a ground wire. For 3-way installations, you will also have two traveler wires.

4.2. Wiring the Dimmer

The LECL-153P-WH-3 dimmer can be wired for single-pole (controlling lights from one location) or 3-way (controlling lights from two locations) applications. Refer to the diagrams below for typical wiring configurations.

Slika 2: Conceptual wiring diagram for a single-pole installation. This image illustrates connecting the dimmer to the hot (line), load, and ground wires. Always ensure proper wire identification before making connections.

• Žica za uzemljenje: Connect the bare copper or green insulated ground wire from the wall box to the green ground wire on the dimmer.
• Jednopolno ožičenje: Connect one black wire from the dimmer to the hot (line) wire from the wall box. Connect the other black wire from the dimmer to the load wire (to the light fixture). Cap off the red/white stripe wire if present.
• 3-smjerno ožičenje: Connect the black wire from the dimmer to the common wire (often darker or marked differently) from the wall box. Connect the red wire from the dimmer to one traveler wire. Connect the red/white stripe wire from the dimmer to the other traveler wire. The other 3-way switch will also need to be wired correctly.
• Osigurajte sve spojeve žičanim konektorima.

4.3. Mounting and Finishing

1. Carefully push all wires back into the wall box.
2. Mount the dimmer to the wall box using the provided screws.
3. Pričvrstite zidnu ploču.
4. Obnovite napajanje: Ponovo uključite struju na prekidaču.

5. Uputstvo za upotrebu

Operating your Lumea CL dimmer is straightforward:

• Uključivanje/isključivanje svjetla: Press the large rocker switch at the top of the dimmer to turn the connected lights on or off.
• Dim/Brighten Lights: Use the vertical slide control on the right side of the dimmer. Slide it up to increase the light intensity (brighten) and slide it down to decrease the light intensity (dim).

6. Advanced Features: Dimming Range Adjustment

The Lumea CL dimmer includes a low-end trim adjustment tab, which allows you to fine-tune the lowest light level for optimal performance with your specific bulbs, especially LEDs. This helps prevent flickering or lights turning off prematurely at low dim settings.

Slika 3: Detail of the low-end trim adjustment tab. This image highlights the small blue tab located on the left side of the dimmer, near the top of the slide control, which can be adjusted to set the minimum dimming level.

6.1. How to Adjust the Low-End Trim

1. Turn the lights on and slide the main dimmer control all the way down to its lowest setting.
2. Locate the small blue tab on the left side of the dimmer, next to the main slide control.
3. Using a small screwdriver or your fingernail, slowly move this blue tab up or down.
4. Adjust the tab until the lights are at their lowest stable dimming level without flickering or turning off.
5. Once the desired low-end is set, the dimmer will remember this setting.

7. Održavanje

Your Lutron dimmer switch requires minimal maintenance.

• čišćenje: To clean the dimmer, wipe with a clean, damp cloth. Do not use any chemical cleaning solutions, as they may damage the finish or internal components.
• Ensure the dimmer is free from dust and debris to maintain optimal performance.

8. Otkrivanje problema

Ako imate problema sa svojim prigušivačem svjetla, pogledajte sljedeće uobičajene probleme i rješenja:

9. Specifikacije

• Model: LECL-153P-WH-3
• Voltage: 120 V~ 60 Hz
• Vrsta opterećenja: 150 W Dimmable LED/CFL or 600 W Incandescent/Halogen
• Vrsta kruga: Jednopolni ili trosmjerni
• Boja: Bijelo
• Način rada: Off, Slide Dimmer
• terminal: Screw
• Vrsta montaže: Pole
• Materijal: Plastic, with metallic components
• Težina artikla: Approximately 0.01 ounces (per unit)
• Dimenzije paketa: 7.48 x 4.72 x 2.52 inča (za pakovanje od 3 komada)
• UPC: 784276801911

10. Garancija i podrška

Lutron Electronics Co., Inc. provides a limited warranty for its products. For specific warranty details, please refer to the warranty card included with your product or visit the official Lutron website. If you require technical assistance or have questions regarding your LECL-153P-WH-3 dimmer, please contact Lutron Customer Support.

Lutron Customer Support:
Webstranica: www.lutron.com
Phone: Refer to the Lutron webstranica za regionalne kontakt brojeve.