Streamlight Stinger LED HL 120/DC PB

Streamlight Stinger LED HL 120/DC PB Flashlight

Uputstvo za upotrebu korisnika

1. Uvod

This manual provides detailed instructions for the safe and effective use of your Streamlight Stinger LED HL 120/DC PB rechargeable flashlight. Please read all instructions carefully before operating the device.

Sigurnosne informacije

  • Do not look directly into the LED light. The intense beam can cause temporary vision impairment.
  • Čuvati van domašaja djece.
  • Use only Streamlight approved batteries and charging equipment.
  • Do not attempt to disassemble the flashlight head or battery pack.
  • Izbjegavajte izlaganje baterijske lampe ekstremnim temperaturama ili korozivnim tekućinama.
Streamlight Stinger LED HL 120/DC PB Flashlight

Figure 1: Streamlight Stinger LED HL 120/DC PB Flashlight. This image shows the blue tactical flashlight with its distinct head and body design.

2. Podešavanje

2.1 Početno punjenje baterije

Your Streamlight Stinger LED HL 120/DC PB flashlight comes with a rechargeable NiMH battery. Before first use, fully charge the battery.

  1. Connect the charging cord to the charger base and plug it into a suitable power source (120V AC or 12V DC).
  2. Insert the flashlight into the charger base. Ensure the charging contacts on the flashlight align with those in the charger.
  3. The charging indicator light on the charger will illuminate, typically red, to indicate charging is in progress.
  4. Allow approximately 10-12 hours for a full charge if the battery is completely depleted. The indicator light may change color (e.g., green) or turn off when charging is complete, depending on the charger model.

2.2 Battery Installation (if required)

The battery is typically pre-installed. If you need to replace or install the battery:

  1. Odvrnite zadnji poklopac baterijske lampe okretanjem suprotno od smjera kazaljke na satu.
  2. Insert the NiMH battery with the positive (+) terminal facing towards the head of the flashlight.
  3. Zavrnite zadnji poklopac u smjeru kazaljke na satu dok se sigurno ne zategne.

3. Uputstvo za upotrebu

The Stinger LED HL 120/DC PB features multiple lighting modes controlled by a single push-button switch.

3.1 Uključivanje/isključivanje i odabir načina rada

  • Za uključivanje: Press and release the push-button switch. The flashlight will activate in the last used mode (High, Medium, or Low).
  • To cycle modes: With the flashlight on, press and release the switch repeatedly within 1.5 seconds to cycle through High, Medium, and Low brightness settings.
  • To activate Strobe: From any mode (on or off), press and hold the switch for approximately 2 seconds. Release to turn off strobe.
  • Za isključivanje: Press and release the switch when the flashlight has been in a single mode for more than 1.5 seconds.

3.2 Recharging the Flashlight

When the light output diminishes, it indicates the battery needs recharging. Follow the steps in Section 2.1 to recharge the flashlight.

4. Održavanje

4.1 Čišćenje

  • Wipe the flashlight body with a damp tkanina. Nemojte koristiti abrazivna sredstva za čišćenje ili rastvarače.
  • Clean the charging contacts periodically with a clean, dry cloth to ensure proper connection.

4.2 Briga o bateriji i zamjena

  • For optimal battery life, avoid fully discharging the battery before recharging.
  • If the flashlight will not be used for an extended period, store it with a partial charge and recharge every few months.
  • Replace the NiMH battery when its run time significantly decreases. Use only genuine Streamlight replacement batteries.

4.3 Skladištenje

Čuvajte baterijsku lampu na hladnom i suvom mestu dalje od direktne sunčeve svetlosti i ekstremnih temperatura.

5. Otkrivanje problema

Pogledajte donju tabelu za uobičajene probleme i njihova rješenja.

ProblemMogući uzrokRješenje
Lampa se ne uključuje.Battery is depleted or improperly installed.Recharge the battery. Check battery orientation. Ensure tail cap is tightened.
Svjetlo je slabo ili treperi.Slaba baterija. Labavi spojevi.Recharge the battery. Ensure tail cap is tightened. Clean charging contacts.
Svjetiljka se ne puni.Charger not powered. Dirty charging contacts. Faulty battery or charger.Check power outlet. Clean charging contacts on flashlight and charger. Try a different power source. Contact customer support if issue persists.

6. Specifikacije

FeatureDetalj
ModelStinger LED HL 120/DC PB
Izvor svjetlostiLED
White Brightness800 lumena (visoka)
Izvor napajanjaBattery Powered
Vrsta baterijeNiMH (nikl-metal hidrid)
Broj baterija1 (uključeno)
MaterijalAluminijum, Metal
BojaPlava
Posebne karakteristikeRechargeable, Multiple lighting modes (High, Medium, Low, Strobe)
Nivo vodootpornostiNije vodootporan
Težina artikla3 funti

7. Informacije o garanciji

Streamlight products are known for their quality and durability. For specific warranty details, including coverage period and terms, please refer to the official Streamlight webweb-mjesto ili garantni list koji ste dobili uz kupovinu. Sačuvajte dokaz o kupovini za slučaj reklamacije.

8. Korisnička podrška

If you have any questions, require technical assistance, or need to report an issue that cannot be resolved using the troubleshooting guide, please contact Streamlight customer support. Visit the official Streamlight website for contact information, including phone numbers and email addresses.

© 2026 Streamlight. All rights reserved. Streamlight and Stinger are registered trademarks of Streamlight, Inc.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.